(de) JUKI machine setup (2)

Translation needed

The content of this page was copied from another page tree and needs to be translated or updated.

When you finish translation, make sure to

Replace the label NEEDS-TRANSLATING with TRANSLATED
Remove this macro from the page

After you add programming to your FactoryLogix assembly, you select the Setup Setup button for every assembly before you generate a machine program. The purpose of the machine Setup dialog is to teach the fiducial shapes and allow you to add any new part numbers to the FactoryLogix Juki IS database.

Juki Part Management and Troubleshooting

To access the Juki Setup dialog, select Part Management and Troubleshooting in the Machine List window (in the Process Definition window).
Select the Setup button.
(Optional) Use CAD Coordinates is a setting that will try and take the coordinates imported from the CAD file and export them into the generated machine program/ This setting ignores any origin set in the Board Geometry area or the ECAD view in the Process Definition window.
(Optional) To treat all images in the Process Definition window as a single board, select the Treat All Images as Single Board check box.
(Optional) Select the Clear Setup button to erase machine setup settings. When the confirmation message displays, select Yes to clear all the Setup dialog settings.

Tip

The Clear Setup button can be very useful. If there are problems with the generated program, use the Clear Setup button and proceed through the machine interface again to address potential rotational, location, and assignment problems.